Barracuda Roller Banner

Select width



Producing Artwork
When producing artwork for printing of the roller banners, please leave bleed all around. 3mm is enough. This ensure a clean edge to your graphic when trimmed. If possible, we would prefer crop marks to the correct size and the bleed to go 3mm beyond. Allow an extra 150mm bleed at bottom for roller unit.
Artwork can be produced in any program but we find high res pdf files are the best option. Pdf artwork is usually supplied quarter size due to the limitations of certain application page sizes but half size or full size is better. Please read the pdf spec sheets we have for these banners, they tell you the panel dimensions and what bleed to leave etc.

Please check stock before ordering.


Back to roller banners